Eastern Cape South Africa
This strong quality 122' Fishing Trawler was built in Spain by a respected yard. The vessel has been recently upgraded and refit as required to make it fully operational and ready to fish. It is equipped to fish mid-ocean or deep ocean depths. There are 2 new fish processing units on board.
This 122' trawler is an excellent value for an up-to-date turn key vessel with current certificates. Delivery can be arranged and quoted upon request.
Skipper's cabin downstairs from the bridge on the port side on deck level.
Chief cabin is situated opposite the skipper�s cabin on the starboard side also on deck level.
One by 2 men cabin and the Officer�s mess between the skipper's and chief�s cabin.
Bosun�s cabin is situated on the starboard side of the vessel and has three bunks.
Adjacent to bosun�s cabin on the starboard side are two cabins with four bunks each for crew.
On port side are two cabins for crew, one with three bunks and the other with four bunks.
Mess room for ratings on the factory deck.
Galley with electric stove, four plates.
Provision stores for dry stores and frozen and fresh victuals.
Showers and toilets on various decks.
|Vessel type:||Custom Stern Trawler|
|Builder:||Construcciones Navales Santo Domingo S.A.|
|Model:||Custom Stern Trawler|
|No. of engines:||1|
|Engine model:||KRUPMAK 6M331AK|
|Drive type:||Shaft drive|
|Length over all:||122'|
|Keel type:||Full Keel|
|Fuel capacity:||54 Cubic Metres|
|Water capacity:||9 Cubic Metres|
Engine Details & Mechanical
Main engine: KRUPMAK 6M331AK, 753 kW (1000 BHP) at 750 rpm
Reduction gear: Single control pitch propeller in Kort nozzle by way of single reduction REINTJIES gearbox
Propeller plant: 4 blade VP propeller in Kort nozzle.
Shaft generators: 1 x 370V 432A 160kW generators for trawl winches
1 x 380V 176A 116kVA alternator for domestic use
Auxiliary engines: 1 x PEGASO GUASCOR Type 9105/7 (1500rpm) with �INDAR� 380V 116kVA alternator
Separators: 1 x ALFA LAVAL MAB103B-24 (F.O. separator)
Air compressors: 1 x QUINCY QR25 and 1 x ABC model VA30
Fish hold: 295.80 m3 stowing 1600 by 70 litre plastic bins
Fuel bunkers: 54.55 m3
Fresh water: 9.88 m3
Ballast water: 11.36 m3
Lubrication Oil: 3.8 m3
Trawl winches: 2 x 14 tons, 1800 metres capacity of 22 mm dia. wire
Electronics & Navigation
Trackplotter I: 1 x Maxsea chart plotter, version 8.1
Trackplotter II: 1 x Sea Wave Seiwa
GPS Navigator I: 1 x Furuno GP- 31 Navigator
Radar: 1 x Furuno RDP 118
Compass I: 1 x magnetic Plath, Madrid compass in binnacle
Autopilot: 1 x Furuno FAP 330
Fish finding equipment:
Echo sounder I: 1 x Furuno FCV 782 Simrad EQ 55
Echo Sounder II: 1 x Furuno FCV 582
Radio transceiver, SSB: 1 x Furuno F5 1503
Satellite: 1 x Inmarsat C, Sailor H 16220
VHF I: 1 x Icom M 45
VHF II: 1 x Uniden Solara
Watch keeping receiver: 1 x Skanti WR
Navtex, 1 x Samyung SNX 200
EPIRB, 1 x Kannad 406
SART, 1 x Kannad
Handheld VHF units, 2 x Icom GM 1500
Other Electronic Equipment: Cavi Comm KV 25T
Construction & Finish
This a Spanish designed and built steel hulled stern trawler with one deck, one bipod stern gantry, raked stem, transom with ramp, double bottom tanks, four bulkheads and single screw presently classed as a Class X stern trawler.
The superstructure is fitted forward of amidships with a signal mast, the aft trawl deck is fitted with a bipod stern gantry with a platform for net storage.
The vessel went through an extensive refit in February 2009, during which period the equivalent of US $ 175,000.00 was spent.
SAMSA Status: Hull annual survey due February 2011
Length overall: 37.16 metres
Registered length: 36.36 metres
Length between perpendiculars: 31.80 metres
Beam: 8.30 metres
Depth to trawl deck: 5.95 metres
Draft: 4.4 metres
Tonnages: 360.97 GRT; 108.29 NRT
SAMSA-mandatory fire fighting equipment:
Fire extinguishers and fire hoses with nozzles
Life saving equipment:
1 x 20 men Viking life raft
1 x 20 men DSB life raft
Various life buoys with MOB, lights and lines
Full set of pyrotechnics flares and rockets
20 x Solas approved life jackets
Fish process equipment:
Standard South African fresh fish H & G hake processing factory:
Conveyor from stocker pond to processing area
Conveyor for deheading with blade
Gutting stations with overboard chute
Conveyors to various accesses to fish hold
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Note: Indicated location is approximate general area only.